Saturday, November 19, 2011

Coolant Level Sensor on Audi A4?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


The details are as follows :----

Coolant Level Sensor


The coolant level sensor, located in the coolant reservoir, sends a signal to the indicator light in the instrument cluster to warn the driver of a low coolant level.
Testing
If the level of the coolant in the reservoir is full, and the indicator light in the instrument cluster is illuminated, proceed as follows:
  1. With the key in the ON position, unplug the harness connector from the coolant reservoir.
  2. Using a suitable jumper wire, connect the two terminals together.
  3. With the key in the ON position, and the terminals bridged, the light in the instrument cluster should extinguish.
  4. If the light extinguishes, replace the coolant level sensor.
  5. If the light continues to illuminate, check the wiring circuit for broken terminals, blown fuses, cut wires, etc. 

---------------

this will help.Thanks.
-----------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment