Friday, November 25, 2011

How to Inspect Vehicles Accumulator/Receiver Dryer ?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

First read and know what is Accumulator and what is its working operation:----
  1. A tank located in the outlet of the evaporator to receive refrigerant that leaves the evaporator. A component used to store or hold liquid refrigerant in an air-conditioning system. This device is constructed to ensure that no liquid refrigerant enters the compressor.
  2. A device that cushions the motion of a clutch and servo action in an automatic transmission.
  3. A register or storage location that forms the result of an arithmetic or logic operation. Commonly used when a series of calculations are to be used.

This is how Accumulator looks:---


Now Go through this Inspecting procedure:----

Air conditioners use either a receiver dryer or an accumulator. These devices vary slightly as to function and differ as to where they are installed in the system:
  • A receiver dryer is installed in the high side.
  • An accumulator is installed in the low side.
A receiver dryer fills and siphons liquid refrigerant from the bottom.
An accumulator separates vapor and liquid. It pulls off vapor from the top. Courtesy of Ford Motor Company.
Some systems have a sight glass on the receiver dryer or in the high pressure liquid line so that unwanted vapor bubbles can be spotted as the system operates. This can give a quick check of whether the refrigerant level is too low. A sight glass is only found on the high pressure side of the system. Also, look for signs of leakage. If you find leaks, replace the part.
An accumulator cannot be serviced. Inspect it to see if it is defective or wet, if so, the entire unit must be replaced. Also check the expansion tube that serves as a metering device to the evaporator. If the expansion tube is clogged, it is again necessary to replace the accumulator.
If you think your accumulator or receiver dryer is defective, you'll need to perform an a/c system test.
---------------
This details will help.
-------------
Also if you have better understanding of other car AC cooling system parts,then it will help more to troubleshoot the problem.
Check the list below or more help.
Its always advisable to know the AC components working and testing procedure,before replacing any part.
For more details regarding cars AC components.Check out the list of links below:---


How to Perform AC Pressure Test?


How to test Cars AC System?


How to inspect Vehicles A/C Compressor and Clutch?


How to Troubleshoot Vehicles AC Cooling Problem?

http://repairhelpcenter.blogspot.com/2011/11/how-to-troubleshoot-vehicles-ac-cooling.html

How to Replace Vehicles A/C Compressor and Clutch Components?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-vehicles-ac-compressor.html

-----------

For car AC related and Heater related solutions. You can refer the options mentioned below:---

Car AC Blows Warm Air ?


How to test AUTO AC pressure?


AUTO Air Conditioning Troubleshooting?



AUTO A/C COOLING PROBLEM?


Fixing refrigerant leak?


How to locate Car AC Refrigerant leak?


CAR AC INTERMITTENT COOLING?


What causes INTERMITTENT COOLING on Car AC system?


Car AC making Noise?


BAD ODOR ON CAR AIR CONDITIONER?



How to Recharge Car's Air Conditioner



For details regarding:--

How does Vehicles Engine cooling system works?


Engine cooling components working?


How to flush cars radiator?






No comments:

Post a Comment