Saturday, November 19, 2011

How to Relieve Fuel System Pressure on Acura Car Models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


The procedure is as follows :----

Relieving Fuel System Pressure


CAUTION
Be sure that the ignition switch is OFF before relieving the fuel system. Never smoke while working on the fuel system!

1.8L, 3.0L & 3.2L ENGINES



See Figure 1
Click image to see an enlarged view
Fig. Fig. 1: Slowly turn the banjo bolt on the fuel filter to relieve the fuel system pressure
  1. Disconnect the negative battery cable.
  2. Remove the fuel filler cap.
  3. Using a 12mm box-end wrench, loosen the banjo bolt from the top of the fuel filter. Be sure to hold the fuel filter with another wrench.
  4. Place a shop towel over the banjo bolt to absorb any fuel that may leak out as the bolt is loosened.
  5. Slowly unscrew the banjo bolt one turn.
  6. Always replace the washers whenever the bolt is loosened.
  7. After the fuel system pressure is relieved, Tighten the service port bolt, install the fuel filler cap, then connect the negative battery cable.

2.2L, 2.3L & 2.5L ENGINES



  1. Disconnect the negative battery cable.
  2. Remove the fuel filler cap.
  3. Use a box-end wrench to loosen the fuel rail service bolt.
See Figure 2
Click image to see an enlarged view
Fig. Fig. 2: Loosening the service bolt from the fuel rail-2.2L engines
  1. Place a shop towel over the banjo bolt to absorb any fuel that may leak out as the bolt is loosened.
  2. Slowly unscrew the banjo bolt one turn.
  3. Always replace the washers whenever the bolt is loosened.
  4. After the fuel system pressure is relieved, Tighten the service port bolt, install the fuel filler cap, then connect the negative battery cable.

3.5L ENGINE



  1. Disconnect the negative battery cable.
  2. Remove the fuel filler cap.
  3. Using a box end wrench, loosen the banjo bolt from the top of the fuel filter. Be sure to hold the fuel filter with another wrench.
  4. Place a shop towel over the banjo bolt to absorb any fuel that may leak out as the bolt is loosened.
  5. Slowly unscrew the banjo bolt one turn.
  6. Always replace the washers whenever the bolt is loosened.
  7. After the fuel system pressure is relieved, Tighten the service port bolt, install the fuel filler cap, then connect the negative battery cable.

-----------------

This details will help.
Thanks.
-------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


No comments:

Post a Comment