Friday, November 18, 2011

How to remove Instrument Cluster on Acura Integra?

The details are as follows :---

Instrument Cluster


REMOVAL & INSTALLATION



See Figures 1 through 5
Click image to see an enlarged view
Fig. Fig. 1: A Phillips screwdriver is needed to remove the trim panel fasteners


Click image to see an enlarged view
Fig. Fig. 2: Remove the trim panel that surrounds the instrument cluster


Click image to see an enlarged view
Fig. Fig. 3: The clear shield can be removed by squeezing the clips along the edges


Click image to see an enlarged view
Fig. Fig. 4: To remove the instrument cluster bulbs turn the holders in the counter-clockwise direction ...


Click image to see an enlarged view
Fig. Fig. 5: ... then pull the bulb and bulb holder from the back of the instrument cluster
  1. Disconnect the negative battery cable.
  2. Lower the steering column and remove the screws that secure the instrument cluster trim to the dash board.
  3. Remove the screws that secure the instrument cluster to the dash assembly.
  4. Pull the instrument cluster out of the dash.
  5. Remove the wiring harnesses and speedometer cable (if applicable) from the back of the cluster.
  6. Remove the instrument cluster from the dash.
To install:
  1. Installation is the reverse of the removal procedure.

------------

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


No comments:

Post a Comment