Friday, November 18, 2011

How to Remove Side Sill Panel on Acura Integra?

Side Sill Panel

The procedure is as follows :---


See Figures 1, 2 and 3
Click image to see an enlarged view
Fig. Fig. 1: Remove the screws from the under side of the side sill panel

Click image to see an enlarged view
Fig. Fig. 2: Pulling the side sill panel away from the rear wheel well

Click image to see an enlarged view
Fig. Fig. 3: View of side sill panel and retaining clips
  1. Remove the side sill panel by removing the necessary screws from the front and rear wheel wells.
  2. Slide the panel forward and remove.
  3. To remove the side sill panel clips, turn them 45°.
To install:
  1. Slide the clips onto the side sill panel.
  2. Install the panel on the car by aligning the clips with the holes in the cars body.
  3. Press lightly to ensure the clips have fully seated in the body.
  4. Install the screws that were removed from the wheel well.


For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.


The car will not start?


Car will not crank?


Car has no spark?


How to troubleshoot car battery?


How to test starter solenoid?


How to test cars starter?

How to replace starter in car?


car will turn over but will not start?


Car wont start?

No comments:

Post a Comment