Friday, November 18, 2011

How to replace Ignition Switch on Acura Car Models?

If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The procedure is as follows :---

Ignition Switch


REMOVAL & INSTALLATION



  1. Disable the air bag system.
  2. Remove the dashboard lower cover.
  3. Remove the knee bolster.
  4. Unplug the connectors from the under-dash fuse block.
  5. Remove the steering column upper and lower covers.
See Figure 1
Click image to see an enlarged view
Fig. Fig. 1: Upper and lower steering wheel assembly covers
  1. Insert the key into the ignition, then place the ignition switch to the "O" position.
  2. Remove the two screws which secure the switch to the mount.
  3. Pull the ignition switch away from the mount.
See Figure 2
Click image to see an enlarged view
Fig. Fig. 2: Exploded view of the ignition switch mounting
  1. Installation is the reverse of the removal procedure.
  2. Enable the air bag system.

-----------
This will help.
Thanks.


For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


No comments:

Post a Comment