Saturday, November 19, 2011

How to replace Instrument Cluster on Acura Car Models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


The procedure is as follows :-----

Instrument Cluster


REMOVAL & INSTALLATION Integra



  1. Disconnect the negative battery cable.
  2. Lower the steering column.
  3. Remove the screws.
  4. Detach any necessary retaining clips.
  5. Remove the instrument cluster as an assembly.
  6. Installation is the reverse of the removal procedure.
CL
  1. Disconnect the negative battery cable.
  2. Lower the steering column.
  3. Remove the cruise control master switch.
  4. Remove the panel brightness controller.
  5. Remove the retaining screws.
  6. Detach any necessary clips.
  7. Remove the instrument cluster as an assembly.
  8. Installation is the reverse of the removal procedure.
See Figure 1
Click image to see an enlarged view
Fig. Fig. 1: Exploded view of the dashboard/steering column lower cover mounting
RL
  1. Disconnect the negative battery cable.
  2. Remove the center air vent from the dash.
  3. Remove the climate control unit and audio unit as a unit.
  4. Remove the dashboard lower cover.
  5. Remove the drivers switch trim.
  6. Remove the screws and clips.
  7. Carefully pull out the instrument panel in the numbered sequence seen in the included art.
See Figure 2
Click image to see an enlarged view
Fig. Fig. 2: Instrument cluster retaining clips and related components
Legend
  1. Disconnect the negative battery cable.
  2. Remove the dashboard lower cover.
  3. Remove the instrument cluster.
See Figure 3
Click image to see an enlarged view
Fig. Fig. 3: Instrument panel/cluster removal
  1. Installation is the reverse of the removal procedure.

BULB REPLACEMENT



See Figures 4 and 5
Click image to see an enlarged view
Fig. Fig. 4: Turn the socket counterclockwise to remove it


Click image to see an enlarged view
Fig. Fig. 5: Pull the bulb straight out to remove it
  1. Disconnect the negative battery cable.
  2. Remove the instrument cluster as outlined in this section.
  3. Turn the desired bulb socket counter clockwise to remove it from the cluster.
  4. Grasp the bulb and pull it straight out to remove it from the socket.
To install:
  1. Place a new bulb into the socket and lightly press it into place.
  2. Place the socket into the cluster and turn the socket clockwise to engage it into the cluster.
  3. Install the instrument cluster.
  4. Connect the negative battery cable.

----------
This details will help.
Thanks.

----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


No comments:

Post a Comment