Friday, November 18, 2011

How to replace Slave Cylinder and bleed Hydraulic system on Acura Car models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The procedure is as follows :----

Slave Cylinder


REMOVAL & INSTALLATION



  1. Locate the slave cylinder.
  2. Remove the flare fitting and steel line from the slave cylinder assembly.
See Figure 1
Click image to see an enlarged view
Fig. Fig. 1: Disconnecting the hydraulic line from the slave cylinder
  1. Remove the slave cylinder from the clutch housing by removing the attaching bolts.
  2. Installation is the reverse of the removal procedure
Use only DOT 3 or 4 brake fluid to refill the clutch hydraulic system.
  1. Fill and bleed the clutch system, using a suitable DOT 3 or 4 brake fluid..

HYDRAULIC SYSTEM BLEEDING



Use only DOT 3 or 4 brake fluid from a clean, sealed container, in the clutch master and slave cylinders. As brake fluid will damage the vehicle's paint, clean up any spills immediately.
  1. Fit a flare or box end wrench onto the slave cylinder bleeder screw.
  2. Attach a rubber tube to the slave cylinder bleeder screw and suspend it into a clear drain container partially filled with brake fluid.
  3. Fill the clutch master cylinder with brake fluid.
  4. Open the bleeder screw and press the clutch pedal to the floor.
  5. Close the bleeder screw.
  6. Release the clutch pedal and recheck the reservoir fluid level. Top off if necessary.
  7. Continue the above procedure until no more bubbles appear in the tube.
  8. Top off the clutch master cylinder reservoir with brake fluid.
---------------

This details will help.
Thanks.

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

No comments:

Post a Comment