Friday, November 18, 2011

How to replace Steering Wheel on Acura Car Models?


If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.

The procedure is as follows :----

Steering Wheel


REMOVAL & INSTALLATION




CAUTION
All models covered by this guide are equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS .

  1. Disable the SRS.
  2. If not already done, disconnect the negative, then the positive battery cables.
  3. Remove the connector between the air bag and the cable reel.
  4. Remove the bolts that hold the air bag module to the steering wheel.
See Figures 1, 2, 3 and 4
Click image to see an enlarged view
Fig. Fig. 1: Location of the 2 air bag module-to-steering wheel retainers.


Click image to see an enlarged view
Fig. Fig. 2: A Torx®driver is required to remove these air bag mounting screws


Click image to see an enlarged view
Fig. Fig. 3: Carefully lift the air bag module from the steering wheel


Click image to see an enlarged view
Fig. Fig. 4: Always carry a live air bag with the trim cover facing away from you
  1. Remove the air bag assembly, holding it away from you in case of accidental deployment.
  2. Detach the connectors for the horn.
  3. If equipped, unplug the cruise control connector.
  4. Unfasten the steering wheel nut.
  5. Remove the steering wheel by rocking it slowly from side to side while pulling steadily with both hands.
See Figure 5
Click image to see an enlarged view
Fig. Fig. 5: Rocking the steering wheel side to side will loosen it from the shaft
To install:
  1. Before installing the steering wheel, center the cable reel by pointing the arrow up. This can be done by rotating the cable reel clockwise until it stops. Then rotate the cable reel about two turns counterclockwise.
  2. Install the steering wheel and make sure the wheel shaft engages the cable reel and canceling sleeve.
See Figure 6
Click image to see an enlarged view
Fig. Fig. 6: When installing the steering wheel on the shaft remember to line up the matchmarks you made
  1. Attach all wires and harnesses.
  2. Install the air bag assembly using new bolts.
  3. Install all covers.
  4. Connect the positive cable first and then the negative. 
  5. After installation, confirm normal system operation and that all controls are working.


---------------

This details will help.
Thanks.

-------------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


No comments:

Post a Comment