Monday, March 5, 2012

Acura Rear Suspension Coil Spring Removal?


Coil Spring
REMOVAL & INSTALLATION

The details are as follows :----


  1. Before servicing the vehicle, refer to the precautions section.
  2. Support the vehicle under the lower control arm.
  3. Remove or disconnect the following:

    Rear wheel
    Stabilizer link from the lower arm
    Wheel speed sensor wiring harness from the lower arm. Do not disconnect the connector.
    Upper shock absorber flange bolt
    Lower control arm bolts
  4. Lower the floor jack and remove the coil spring and spring seats.

    Click image to see an enlarged view
    Fig. Exploded view of the rear spring assembly
To install:

NOTE
Use new self-locking nuts for assembly.

  1. Place the coil spring and spring seats on the lower control arm and raise into position. Tighten the inboard bolt to 61 ft. lbs. and the outer bolt to 54 ft. lbs. (74 Nm).
  2. Install or connect the following:

    Rear wheel


This details will help.
Thanks.

FOR MORE HELP GO TO:----

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


3 comments:

  1. Warm Greetings!




    Today, I visit your website and after reading your blog i realize that it is very informative. I'm highly impressed to see the comprehensive resources being offered by your site.


    Thanks and Regards



    coil spring

    ReplyDelete
  2. This comment has been removed by the author.

    ReplyDelete