Thursday, March 15, 2012

Charging The AC System For Ford Fusion, Lincoln MKZ & Mercury Milan?


The procedure is similar for both Ford, Lincoln and Mercury car models:----

The procedure to charge the AC system is as follows:----

Charging The System
USING AN R-134A SERVICE CENTER
WITHOUT AN R-134A SERVICE CENTER

Using An R-134A Service Center



Specific to:
Ford Fusion 2008-2009
Lincoln MKZ 2008-2009
Mercury Milan 2008-2009

CAUTION
Refer to the applicable precautions for this system before performing the following operation. Failure to follow the warnings and cautions could result in possible personal injury or death.


NOTE
Ford Motor Company recommends use of an A/C service center to carry out recovery, evacuation and charging of the refrigerant system. If an A/C service center is not available, refrigerant system recovery, evacuation and charging may be accomplished using a separate recovery station, vacuum pump, charging meter and manifold gauge set.


NOTE
Leaks in refrigerant system service equipment, hoses or gauges can cause a leak that may be misinterpreted as a problem with the vehicle's refrigerant system. It is necessary to leak-test all refrigerant system service equipment, hoses and gauges on a weekly basis to verify that no leaks are present.

  1. Lubricate the refrigerant system with the correct amount of clean PAG oil.
  2. Connect an R-134a A/C service center to the low-side and high-side service gauge port valves following the operating instructions provided by the equipment manufacturer.
  3. Set the refrigerant charge amount, and charge the refrigerant system following the instructions provided by the equipment manufacturer.

Without An R-134A Service Center



Specific to:
Ford Fusion 2008-2009
Lincoln MKZ 2008-2009
Mercury Milan 2008-2009

CAUTION
Refer to the applicable precautions for this system before performing the following operation. Failure to follow the warnings and cautions could result in possible personal injury or death.


NOTE
Ford Motor Company recommends use of an A/C service center to carry out recovery, evacuation and charging of the refrigerant system. If an A/C service center is not available, refrigerant system recovery, evacuation and charging may be accomplished using a separate recovery station, vacuum pump, charging meter and manifold gauge set.


NOTE
Leaks in refrigerant system service equipment, hoses or gauges can cause a leak that may be misinterpreted as a problem with the vehicle's refrigerant system. It is necessary to leak-test all refrigerant system service equipment, hoses and gauges on a weekly basis to verify that no leaks are present.

  1. Lubricate the refrigerant system with the correct amount of clean PAG oil.
  2. Assemble the R-134a manifold gauge set, automatic refrigerant charging meter and R-134a supply tank following the automatic refrigerant charging meter operating instructions.
  3. Charge the refrigerant system following the automatic refrigerant charging meter operating instructions.
  4. If the refrigerant flow stops before the refrigerant charge is complete, start the engine, select A/C operation and allow the refrigerant charge to complete.


These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment