Monday, March 5, 2012

Front Crankshaft Seal Removal on Acura?


Front Crankshaft Seal
REMOVAL & INSTALLATION: ---

The details are as follows :----


  1. Before servicing the vehicle, refer to the precautions section.
  2. Remove or disconnect the following: 

    Negative battery cable
    Accessory drive belts
    Side engine mount
    Valve cover
    Crankshaft pulley
    Front cover
    Balance shaft belt, if equipped
    Timing belt
    Top Dead Center (TDC) sensor, if equipped
    Crankshaft timing sprocket
    Front crankshaft seal 

    image
    Fig. Front crankshaft seal installation
To install:
  1. Lubricate the crankshaft seal lip with grease prior to installation.
  2. Install the front crankshaft seal so that it is flush with the surface of the oil pump housing.
  3. Install or connect the following:

    Crankshaft timing sprocket
    Top Dead Center (TDC) sensor, if equipped
    Timing belt
    Balance shaft belt, if equipped
    Front cover
    Crankshaft pulley. Tighten the bolt to 181 ft. lbs. (245 Nm) on 2001-02 models, or 47 ft. lbs. (64 Nm) plus an additional 60 degrees on 2003-06 models.
    Valve cover
    Side engine mount
    Accessory drive belts
    Negative battery cable
  4. Check the engine oil level and add if necessary.
  5. Start the engine and check for leaks.

This will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?





No comments:

Post a Comment