Friday, March 2, 2012

How to remove power steering pulley on 2002 Ford Taurus?

Ford taurus power steering pulley.
Pulley can be removed by a tool.
Its a special tool.


You will need a special power steering pump pulley removal tool:
 With the help of the tool,the procedure is as follows :--------

See the tool shown below :----
graphic

Disconnect the negative battery cable.
Remove the accessory drive belt.
Drain and remove the radiator coolant recovery reservoir.
Position a drain pan under the power steering pump. Disconnect the powersteering pump reservoir hose and allow it to drain.
Using Pulley Remover T69L-10300-B, or equivalent, remove the pulley from the power steering pump shaft .
Disconnect the left turn pressure hose from the power steering pump and allow it to drain.
Remove the power steering pump retaining bolts and the pump.
To install:
Install the power steering pump and tighten bolts to 15-22 ft. lbs. (20-30 Nm).
Connect the left turn pressure hose and secure clamp.
Using a Steering Pump Pulley Replacer T65P-3A733-C, or equivalent, install the power steering pump pulley: the pulley face must be flush with the pump shaft or within 0.010 inch (0.25mm).
Fill the power steering reservoir with power steering fluid. Connect the negative battery cable.
Start the engine and check for leaks and proper operation. Bleed the power steering system if needed.
BLEEDING
Disable the ignition by disconnecting the ignition module or disconnecting the camshaft position sensor.
Raise and safely support the vehicle so the front wheels are off the floor.
Place jackstands under the front of the vehicle.
Fill the power steering fluid reservoir.
Crank the engine with the starter motor and add fluid until the level remains constant.
While cranking the engine, rotate the steering wheel from lock-to-lock.
The front wheels must be off the floor during lock-to-lock rotation of the steering wheel. Do not hold the steering wheel on the stops.
Check the fluid level and add fluid, if necessary.
Enable the ignition system. Start the engine and allow it to run for several minutes.
Rotate the steering wheel from lock-to-lock.
Stop the engine and check the fluid level. Add fluid, if necessary.
If air is still present in the system, purge the system of air using Power Steering Air Evacuator 021-00014 or equivalent, as follows:
Make sure the power steering pump reservoir is full to the COLD FULL mark on the dipstick or to just above the minimum indication on the reservoir.
Tightly insert the rubber stopper of the air evacuator assembly into the pump reservoir fill neck.
Apply 20 inch Hg maximum vacuum on the pump reservoir for a minimum of 3 minutes with the engine idling. As air purges from the system, vacuum will fall off. Maintain adequate vacuum with the vacuum source.
Release the vacuum and remove the vacuum source. Fill the reservoir to the COLD FULL mark or to just above the minimum indication on the reservoir. Install the evacuator tool again.
With the engine idling, apply 20 inch Hg vacuum to the pump reservoir. Slowly cycle the steering wheel from lock-to-lock every 30 seconds for approximately 5 minutes. Do not hold the steering wheel on the stops while cycling. Maintain adequate vacuum with the vacuum source as the air purges.
Release the vacuum and remove the vacuum source. Add fluid, if necessary.
Start the engine and cycle the steering wheel. Check for oil leaks at all connections. In severe cases of aeration, it may be necessary to repeat the procedure.
Remove the jackstands.
Lower the vehicle.
Check the power steering system for proper operation.

This details will help.
Thanks.

See below latest solved car problems :----

How to replace Tie Rod Ends on Chevy silverado 2500HD?

http://technoanswers.blogspot.in/2012/02/how-to-replace-tie-rod-ends-on-chevy.html

How to replace steering linkage on Chevrolet Silverado 2500 HD?

http://technoanswers.blogspot.in/2012/02/how-to-replace-steering-linkage-on.html

How to Replace power steering pump on Chevy silverado 2500 HD?

http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-pump-on.html

How to replace Power steering rack and pinion gear on Chevy Silverado 2500 HD?

http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-rack-and.html

Power Recirculating Ball Steering Gear removal on Chevy silverado 2500 HD?

http://technoanswers.blogspot.in/2012/02/power-recirculating-ball-steering-gear.html

Chevy Silverado 2500 HD steering wheel replacing Procedure?

http://technoanswers.blogspot.in/2012/02/chevy-silverado-2500-hd-steering-wheel.html

Steering Wheel Locked?

               

How to replace Power Rack and Pinion Steering Gear on Acura Car Models?


How to replace Power Steering Pump on Acura Car Models?

Also bleeding:
               

How to replace Steering Linkage on Acura Car Models?


How to replace Steering Wheel on Acura Car Models?

How to replace Power Steering Pump on 1999 Acura TL?

How to Disarming the Air Bag System?

How to remove steering wheel on Chevrolet Malibu?

How to Remove Power steering Pressure Hose on Dodge Stratus

Car steering wheel makes noise?

Car makes clicking or tapping sound?

How to replace power steering pump on Mitsubishi Diamante?

How to bleed power steering pump on Toyota?

How to replace steering wheel on Toyota Land cruiser?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-steering-wheel-on-toyota.html

How to replace power steering pump on Toyota Land cruiser?

Steering service light ON GMC Sierra Denali?

Steering service light came on 2004 Pontiac Grand Prix

Check power steering message on Toyota?

http://schematicsdiagram.blogspot.in/2012/02/check-power-steering-message-on-toyota.html


No comments:

Post a Comment