Sunday, March 11, 2012

How to replace Accessory Drive belts For 2005 Ford Taurus?


The instructions are similar for 2000 to 2005 Ford Taurus.

The details to Replace Accessory Drive Belts are as follows :----

Accessory Drive Belts
ADJUSTMENT
DRIVE BELT ROUTINGS
INSPECTION
REMOVAL & INSTALLATION

Adjustment



The drive belt tension is maintained by an automatic belt tensioner and does not require adjustment.

Drive Belt Routings





image
Fig. Serpentine accessory drive belt routing-3.0L (VIN U) engine


Click image to see an enlarged view
Fig. Serpentine accessory drive belt routing-3.0L (VIN S) engine


Click image to see an enlarged view
Fig. Serpentine accessory drive belt routing-Ford 3.0L (VIN U) engines


Click image to see an enlarged view
Fig. Serpentine accessory drive belt routing-Ford 3.0L (VIN S) engine


Click image to see an enlarged view
Fig. Serpentine accessory drive belt routing-Ford 3.4L SHO engine


Click image to see an enlarged view
Fig. Water pump drive belt routing-Ford 3.4L SHO engine


Click image to see an enlarged view
Fig.

Inspection



Inspect the drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the inner edge of the belt and run outward. All worn or damaged drive belts should be replaced immediately.

Removal & Installation




NOTE
When installing the drive belt on the pulleys, make sure all the V-grooves make proper contact with the pulleys.


WARNING
Use caution when removing or installing the belt and make sure the tool does not slip from the drive belt tensioner or personal injury or damage to the belt tensioner and the belt may occur.

  1. Attach a 15mm socket or wrench to the bolt attaching the tensioner pulley.
  2. On all 3.0L (OHV) engines, rotate the drive belt tensioner clockwise to relieve belt tension and slide the belt off the pulleys.
  3. On 3.0L (DOHC) engines, rotate the tensioner counterclockwise to relieve belt tension and slide the belt off the pulleys.

    Click image to see an enlarged view
    Fig. Rotate the belt tensioner and . . .


    Click image to see an enlarged view
    Fig. . . . remove the belt from around one of the pulleys to remove the belt


    Click image to see an enlarged view
    Fig. This label, usually affixed in the engine compartment, will give a diagram of the belt routing


    Click image to see an enlarged view
    Fig. A very useful tool kit is available to use for releasing the spring loaded belt tensioner


    Click image to see an enlarged view
    Fig. Place the proper size socket into the release bar


    Click image to see an enlarged view
    Fig. Some vehicles use a 3/8 or 1/2 drive opening on the tensioner


    Click image to see an enlarged view
    Fig. An extension is available , if needed, to avoid components obstructing the path to the tensioner


    Click image to see an enlarged view
    Fig. Just place the extension on the end of the release bar and tighten the retaining bolt
To install:
  1. Install the drive belt on all the pulleys except the tensioner pulley.
  2. Rotate the belt tensioner as outlined in the removal procedure to relieve belt tension and install the belt onto the tensioner pulley. Make sure the V-grooves make proper contact with the pulleys. Make sure the spring keeper releases or improper belt tension will occur.

This will help.
Thanks.

                     

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html


No comments:

Post a Comment