Monday, March 12, 2012

How to replace Ford Windstar Power Steering pump?

The power steering pump replacing details are as follows :---
Removal & Installation:--


  1. Disconnect the negative battery cable.
  2. Remove the accessory drive belts.
  3. Remove the alternator.
  4. Remove the accessory drive belt tensioner.
  5. Remove the power steering pump pulley using a Steering Pump Pulley Remover (T69L-10300-B) or equivalent.
  6. Position a drain pan under the power steering pump.
  7. Disconnect the power steering pump pressure and return hoses.
  8. Remove the power steering pump retaining bolts (three in the front, one in the rear) and remove the pump from the support.
  9. Remove the pump support from the pump. 

    image
    Fig. The power steering pump pulley must be removed prior to removal of the power steering pump
To install:
  1. Install the pump support on the pump and tighten the fasteners to 30-40 ft. lbs. (40-55 Nm).
  2. Install the pump and tighten the retaining bolts to 30-40 ft. lbs. (40-55 Nm).
  3. Connect the power steering pump pressure and return hoses.
  4. Install the power steering pump pulley using a Steering Pump Pulley Installer (T65P-3A733-C) or equivalent.
  5. Install the accessory drive belt tensioner.
  6. Install the alternator.
  7. Install the accessory drive belts.
  8. Connect the negative battery cable.
  9. Fill the power steering reservoir with premium power steering fluid to theCOLD FILL line on the dipstick.

This details will help.
Thanks.



No comments:

Post a Comment