Sunday, March 11, 2012

How to replace Oil Pump on 2007 Ford Taurus?


The instructions are similar for 2006 and 2007 ford Taurus Car models.

Oil Pump
REMOVAL & INSTALLATION  Details are as follows :---
Follow the instructions with details and diagrams :---

3.0L Engine
VIN S Engine
  1. Before servicing the vehicle, refer to the precautions section.
  2. Remove the oil pan.
  3. Remove the nut, bolts and the oil pump screen and pick-up tube.
  4. Remove and inspect the O-ring seal.
  5. Remove the pump bolts in the sequence shown and remove the oil pump. 
    image

    Fig. Oil pump loosening sequence-3.0L (VIN S) Engine
To install:
  1. Position the oil pump and install the bolts in the sequence shown. Tighten to 89 inch lbs. (10 Nm).
  2. Install a new O-ring seal.
  3. Install the oil pump screen and pick-up tube. Tighten the nut in two steps:
    1. Step 1: Tighten to 89 inch lbs. (10 Nm).
    2. Step 2: Tighten an additional 45 degrees.
  4. Install the oil pan. 

    image
    Fig. Oil pump tightening sequence-3.0L (VIN S) Engine
VIN U, 2 Engines
  1. Before servicing the vehicle, refer to the precautions section.
  2. Remove the oil pan.
  3. Remove the bolts and the oil pump.
  4. Clean all the sealing surfaces.
To install:
  1. Installation is the reverse of removal, tighten the oil pump bolts to 35 ft. lbs. (48 Nm).


                     

FOR MORE HELP GO TO: ---

Car repair guide?



No comments:

Post a Comment