Thursday, March 15, 2012

How To Replace Oil Pump on Ford Expedition and Lincoln Navigator?


The procedure is similar for both ford and Lincoln car models:-----

 Oil Pump
REMOVAL & INSTALLATION Details are as follows:----

  1. Before servicing the vehicle, refer to the precautions section.
  2. Disconnect the negative battery cable.
  3. Remove the timing drive components.
  4. Remove the oil pan.
  5. Remove the 3 bolts and the oil pump screen and pickup tube.
  6. Remove the 3 bolts and the oil pump. 

    image
    Fig. Removing the 3 bolts and oil pump
To install:

NOTE
Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.

  1. Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging. Inspect the mating surfaces.
  2. Position the oil pump and install the 3 bolts.
    NOTE
    Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil pressure and severe engine damage.


    NOTE
    Clean and inspect the mating surfaces and install a new O-ring. Lubricate the O-ring with clean engine oil prior to installation.
  3. Position the oil pump screen and pickup tube and install the 3 bolts.
    1. Tighten the 2 oil pump screen and pickup tube-to-oil pump bolts to 89 inch lbs. (10 Nm).
    2. Tighten the oil pump screen and pickup tube-to-spacer bolt to 18 ft. lbs. (25 Nm).
  4. Install the oil pan.
  5. Install the timing drive components.



These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment