Tuesday, March 6, 2012

How to replace water pump on Acura?


Water Pump
REMOVAL & INSTALLATION: ---


  1. Before servicing the vehicle, refer to the precautions section.
  2. Drain the cooling system.
  3. Remove or disconnect the following: 

    Negative battery cable
    Accessory drive belts
    Front cover
    Timing belt
    Timing belt tensioner
    Water pump 
    image 

    Fig. Exploded view of the water pump mounting
To install:
  1. Install or connect the following:

    Water pump. Use a new O-ring seal and tighten the bolts to 105 inch lbs. (12 Nm).
    Timing belt tensioner
    Timing belt
    Front cover
    Accessory drive belts
    Negative battery cable
  2. Fill the cooling system.
  3. Start the engine and check for leaks.

The details will help.
Thanks.
FOR MORE HELP GO TO: ---

Car repair guide?




No comments:

Post a Comment