Friday, March 9, 2012

How to replace Wheel Speed Sensors?

The details are ford and Mercury vehicles.


Wheel Speed Sensor Rings (Toothed Rings)
REMOVAL & INSTALLATION

The front wheel speed sensor rings are integral to the front hub and bearing assemblies.


Wheel Speed Sensors
REMOVAL & INSTALLATION

Instructions are as follows :----
Front Wheel
  1. With the vehicle in NEUTRAL, position it on a hoist.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 2 scrivets and position aside the fender splash shield.
  4. Remove the wheel speed sensor harness pin-type retainer.
  5. Remove the 2 wheel speed sensor harness retainers.
  6. Remove the bolt and the wheel speed sensor.
To install:
  1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).
Rear Wheel
All Wheel Drive
Specific to:
Ford Taurus 2008-2009
Mercury Sable 2008-2009
  1. With the vehicle in NEUTRAL, position it on a hoist.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the wheel speed sensor bolt.
  4. On the left side, release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
  5. Release the wheel speed sensor harness spring clip and the 2 pin-type retainers from the rear control arm.
  6. On the right side, release the 3 pin-type retainers and remove the wheel speed sensor.
To install:
  1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).
Front Wheel Drive Models
Specific to:
Ford Taurus 2008-2009
Mercury Sable 2008-2009
  1. With the vehicle in NEUTRAL, position it on a hoist.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 2 rivets and position aside the fender splash shield.
  4. Remove the wheel speed sensor harness pin-type retainer.
  5. Remove the 2 wheel speed sensor harness retainers.
  6. Remove the bolt and the wheel speed sensor.
To install:
  1. To install, reverse the removal procedure and tighten the speed sensor bolt to 71 inch lbs. (8 Nm).


This details will help.
Thanks.





No comments:

Post a Comment