Monday, March 5, 2012

Idle Valve replacing on Acura?

Please Note This details and procedure are For Acura 1986 to 1993 car models.
Its For Acura Integra,Legend and Vigor car models.

The details are as follows :-----

Electronic Air Control Valve (EACV) Fast Idle Valve Air Boost Valve


These air control valves are located at the side of the intake chamber or plenum downstream of the throttle body. On Integra vehicles, the fast idle valve is located in the emission control box.
Disconnect the wiring connector at the valve.
Label and disconnect the vacuum hoses from the unit.
Remove the mounting bolts and remove the valve. Recover and discard the O-rings from the vacuum ports.

The fast idle valve is factory adjusted; it should not be disassembled or altered.

To install:
Replace the O-rings and make certain they are properly seated.
Install the valve and the retaining bolts. The pintle or control valve for the EACV must seat correctly in its port. Tighten the bolts to 9 ft. lbs. (12 Nm).
Connect the vacuum hoses to the valve; make certain each hose is connected to the proper port. Connect the electrical connector.

This details will help.

See below latest solved car problems :-----

Clutch pedal drags and grabs while changing gears?

Clutch slipping problem?

How to open Stuck up bonnet on Volvo s40?

Camshaft Position Sensor TESTING on Ford Focus?


How to remove Rear Adjustable Arm on 2007 Toyota Camry?

Engine stalls when gas is given?

4x4 front differential will not engage the axle on ford?

Maf sensor diagram for a 2003 ford explorer?

1990 mazda 323 stalls and quit running?

Where is Crankshaft position sensor located on Toyota Tundra?

Ford Focus Crankshaft Position (CKP) Sensor?

Main fuse popping when connecting battery?

Nissan car will not start?

Delay starting on Toyota Prius?

No comments:

Post a Comment