Monday, March 5, 2012

Oil Pan Replacing on Acura?


Oil Pan
REMOVAL & INSTALLATION: ---


  1. Before servicing the vehicle, refer to the precautions section.
  2. Drain the engine oil.
  3. Remove or disconnect the following:

    Negative battery cable
    Front splash shield
    Heated Oxygen (HO 2 S) sensor connector
    Exhaust front pipe
    Torque converter cover, if equipped with an automatic transaxle
    Oil pan
To install:
  1. Install the oil pan. Apply liquid gasket as shown. 

    image
    Fig. Apply liquid gasket to the inner threads of the bolt holes and the engine block along the area indicated by the broken line-MDX
  2. Tighten the bolts in sequence to 105 inch lbs. (12 Nm) using several passes. 

    image
    Fig. Oil pan tightening sequence-MDX
  3. Wait at least 30 minutes before adding oil to the engine.
  4. Install or connect the following:

    Torque converter cover, if removed
    Exhaust front pipe
    Subframe center beam, if removed
    HO 2 S sensor connector
    Front splash shield
    Negative battery cable
This will help.
Thanks.



FOR MORE HELP GO TO: ---

Car repair guide?




No comments:

Post a Comment