Tuesday, March 6, 2012

Oil Pump Replacing on Acura?


Oil Pump
REMOVAL & INSTALLATION: ---

The details are as follows :----


  1. Before servicing the vehicle, refer to the precautions section.
  2. Drain the engine oil.
  3. Remove or disconnect the following: 

    Negative battery cable
    Accessory drive belts
    Front cover
    Timing belt
    Timing belt idler pulley
    Crankshaft Position (CKP) sensor
    Crankshaft timing sprocket
    Variable Valve Timing and Valve Lift Electronic Control (VTEC) solenoid valve connector
    Oil filter adapter
    Oil pan
    Oil pump pickup tube
    Oil pump 

    image
    Fig. Exploded view of the oil pump assembly
To install:

NOTE
Use new gaskets and O-ring seals for assembly.

  1. Apply liquid gasket to the oil pump and to the bolt hole threads.
  2. Install or connect the following:

    Oil pump. Tighten the bolts to 105 inch lbs. (12 Nm).
    Oil pump pickup tube. Tighten the bolts to 105 inch lbs. (12 Nm).
    Oil pan
    Oil filter adapter
    VTEC solenoid valve connector
    Crankshaft timing sprocket
    CKP sensor
    Timing belt idler pulley
    Timing belt
    Front cover
    Accessory drive belts
    Negative battery cable
  3. Fill the crankcase to the correct level.
  4. Start the engine and check for leaks.


This will help.
Thanks.


FOR MORE HELP GO TO: ---

Car repair guide?

1 comment:

  1. Great thoughts you got there, believe I may possibly try just some of it through out my daily life.
    Dow Corning DC 976 vacuum grease

    ReplyDelete