Tuesday, March 6, 2012

Rear Main Seal Replacing on Acura?


Rear Main Seal
REMOVAL & INSTALLATION: ----


Before servicing the vehicle, refer to the precautions section.
Remove or disconnect the following: 

Transaxle
Clutch pressure plate and disc, if equipped
Flywheel
Oil seal


To install:

Install or connect the following: 

Oil seal. Drive the seal square into the seal case.
Flywheel. Tighten the bolts in a crossing pattern to 54 ft. lbs. (73 Nm).
Clutch pressure plate and disc, if equipped
Transaxle

Check the fluid levels.
Start the engine and check for leaks.


This will help.
Thanks.


FOR MORE HELP GO TO: ---

Car repair guide?



No comments:

Post a Comment