Thursday, March 22, 2012

Starter Replace for Buick & Pontiac Montana?


PLEASE NOTE:--The Procedure is Similar for Chevrolet Uplander, Pontiac Montana, Saturn Relay, Buick Terraza car models.

Starter
REMOVAL & INSTALLATION details are as follows:----

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Negative battery cable
    Radiator air baffle, for clearance if necessary
    Flywheel inspection cover bolts
    Flywheel inspection cover
    Electrical connections from the starter motor
    Starter motor mounting bolts
    Starter motor
image 
Fig. Showing the starter motor location and electrical connections
To install:
  1. Install or connect the following:
    NOTE
    Before installing the starter motor to the engine, tighten the nut next to the cap on the solenoid BAT terminal. If this terminal is not tight in the solenoid cap, the cap may be damaged during installation of electrical connections and cause the starter motor to fail later.






    Starter motor
    Starter motor mounting bolts and tighten the bolts to 30 ft. lbs. (40 Nm)
    Electrical connection to the battery terminal on the solenoid and tighten the battery terminal nut to 13 ft. lbs. (17 Nm)
    Electrical connections to the S terminal on the solenoid and tighten solenoid S terminal nut to 27 inch lbs. (3 Nm)
    Flywheel inspection cover
    Flywheel inspection cover bolts
    Radiator air baffle, if removed
  2. Connect the negative battery cable


These details will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html



No comments:

Post a Comment