Tuesday, June 26, 2012

1995 Ford Taurus: Ignition switch not turning OFF?

Ignition switch replaced.The relays and fuses all checked ok.

But still the ignition switch will not turn off.

Try this, hot feed the fuse panel to make it run and turn off.

If this works,then problem is not ignition switch or relay or fuse.


The problem is  broken actuator rod in the steering column. It is a plastic rod with a metal pin the actuates the plastic rod for the ignition switch to turn the vehicle off. You can start the vehicle with the key because the two rods push against each other to start the car is there. But when you go to turn the vehicle off with the key, the rod will not pull the other rod for the ignition switch to turn the engine off because the pin has fallen out. The stering column will have to be removed from the vehicle and disassembled to replace the actuator rod. The  steering column needs to be disassembled. If you have no expierience with steering columns, it is very daunting to perform the job.Get it done at professional garage.

This will help.
Thanks,.



Users Who Viewed This Problem Also Viewed:

How to replace Ignition Switch on Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-ignition-switch-on-acura.html

How to remove ignition switch on VW Car models?
http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html

How to Replace Ignition Switch on Chevrolet Caprice Classic?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html

For All types of Car models and brands help 
Go to Newly Launched

FREE Car repair guide? 
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html 

& 
Complete Car repair Help FREE? 
http://repairhelpcenter.blogspot.in/2012/03/complete-car-repair-help.html




No comments:

Post a Comment